Bose SoundTouch 서비스 매뉴얼 - 페이지 35

{카테고리_이름} Bose SoundTouch에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose SoundTouch 39 페이지. Wireless pedestal
Bose SoundTouch에 대해서도 마찬가지입니다: 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (9 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (5 페이지), 여기에서 시작하기 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

SERIAL NUMBER AND COUNTRY CODE PROGRAMMING

Perform both of these procedures any time

the Wi-Fi Module is replaced.

Download two macros from the

SoundTouch

product's repair information

page located on http://serviceops.bose.com.

Place these macros in the Tera Term pro-

gram folder.

set_serial_number.ttl

set_country_code.ttl

1. Setting the Serial Number

1.1 Connect the SoundTouch wireless

pedestal to a computer as shown in the TAP

command setup procedure on pages 31 -

32.

1.2 Within Tera Term, select Control then

Macro and Select the file -

"set_serial_number.ttl"

1.3 Follow the prompts.

2. Setting the Country Code

2.1 Connect the SoundTouch wireless

pedestal to a computer as shown in the TAP

command set up procedure on pages 31 -

32.

2.2 Within Tera Term, select Control then

Macro and Select the file -

"set_country_code.ttl"

2.4 Follow the prompts.

Note: Selecting us sets the Wi-Fi module to

the US standard channels 1-11. Selecting eu

sets the Wi-Fi module to EU standard

channels 1-13

3. Reading the Country Code.

3.1 Type the command "local_services on"

and <enter>. Then press CTRL-C on the

keyboard. Then type "e" and <enter>. The

command line lisa login: should be displayed

on the computer.

3.2 Type the command "root" and <enter>.

The command line should be

root@lisa:root#.

3.3 Enter "cat /var/tmp/mfgdata.xml". The

country code is displayed in the first line of

the response.

3.4 Return to CLI prompt by entering the

command "rm /mnt/nv/local_services" and

<enter>.

3.5 Enter the command "exit" and <enter>.

This will return to the TAP interface (CLI) and

a TAP command line "->" should be shown.