Bose SoundTouch Panduan Servis - Halaman 35

Jelajahi secara online atau unduh pdf Panduan Servis untuk Pembicara Bose SoundTouch. Bose SoundTouch 39 halaman. Wireless pedestal
Juga untuk Bose SoundTouch: Panduan Pemilik (33 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (2 halaman), Manual (9 halaman), Panduan Pemilik (20 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (5 halaman), Mulai dari Sini Manual (20 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pemilik (18 halaman), Panduan Memulai Cepat (5 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak

SERIAL NUMBER AND COUNTRY CODE PROGRAMMING

Perform both of these procedures any time

the Wi-Fi Module is replaced.

Download two macros from the

SoundTouch

product's repair information

page located on http://serviceops.bose.com.

Place these macros in the Tera Term pro-

gram folder.

set_serial_number.ttl

set_country_code.ttl

1. Setting the Serial Number

1.1 Connect the SoundTouch wireless

pedestal to a computer as shown in the TAP

command setup procedure on pages 31 -

32.

1.2 Within Tera Term, select Control then

Macro and Select the file -

"set_serial_number.ttl"

1.3 Follow the prompts.

2. Setting the Country Code

2.1 Connect the SoundTouch wireless

pedestal to a computer as shown in the TAP

command set up procedure on pages 31 -

32.

2.2 Within Tera Term, select Control then

Macro and Select the file -

"set_country_code.ttl"

2.4 Follow the prompts.

Note: Selecting us sets the Wi-Fi module to

the US standard channels 1-11. Selecting eu

sets the Wi-Fi module to EU standard

channels 1-13

3. Reading the Country Code.

3.1 Type the command "local_services on"

and <enter>. Then press CTRL-C on the

keyboard. Then type "e" and <enter>. The

command line lisa login: should be displayed

on the computer.

3.2 Type the command "root" and <enter>.

The command line should be

root@lisa:root#.

3.3 Enter "cat /var/tmp/mfgdata.xml". The

country code is displayed in the first line of

the response.

3.4 Return to CLI prompt by entering the

command "rm /mnt/nv/local_services" and

<enter>.

3.5 Enter the command "exit" and <enter>.

This will return to the TAP interface (CLI) and

a TAP command line "->" should be shown.