Bose Virtually Invisible 791 설치 매뉴얼 - 페이지 5
{카테고리_이름} Bose Virtually Invisible 791에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Virtually Invisible 791 23 페이지. Installation guide
Bose Virtually Invisible 791에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 설치 매뉴얼 (35 페이지)
페이지 인쇄
Selecting speaker cable
If your cables are not yet installed, use these guidelines
for choosing and using speaker cable. If your cables are
already installed, check to be sure they meet these
standards.
Gauge
Maximum Length
18 AWG (0.82 mm
2
)
20 ft (6 m)
16 AWG (1.3 mm
2
)
30 ft (9 m)
14 AWG (2.1 mm
2
)
50 ft (15 m)
12 AWG (3.3 mm
2
)
90 ft (27 m)
Consider the location of the speakers and be sure to
allow enough cable to reach each one. This includes the
extra length needed for wiring the speaker before
inserting it into the ceiling.
PREPARATION
Preparing the cable wires
Speaker cable consists of two insulated wires. The
insulation around one wire is marked (striped, collared,
or ribbed) to identify it as positive. The other wire is
negative.
Note: It is sometimes difficult to distinguish wire
markings. Inspect both wires carefully.
1. Strip approximately '/2 in. (13 mm) of insulation from
both wires.
2. Twist the bare end of each wire so loose strands will
not touch across terminals.
Be sure to connect each wire to the proper speaker
terminal, positive to positive (+) and negative to
negative (-).
Note: For information on installing cable, consult
a
professional electrician
or
audio/video installer,
or
look
for reference books at
a
local home building retail store.
3
Selecting speaker cable
If your cables are not yet installed, use these guidelines
for choosing and using speaker cable. If your cables are
already installed, check to be sure they meet these
standards.
Gauge
Maximum Length
18 AWG (0.82 mm
2
)
20 ft (6 m)
16 AWG (1.3 mm
2
)
30 ft (9 m)
14 AWG (2.1 mm
2
)
50 ft (15 m)
12 AWG (3.3 mm
2
)
90 ft (27 m)
Consider the location of the speakers and be sure to
allow enough cable to reach each one. This includes the
extra length needed for wiring the speaker before
inserting it into the ceiling.
PREPARATION
Preparing the cable wires
Speaker cable consists of two insulated wires. The
insulation around one wire is marked (striped, collared,
or ribbed) to identify it as positive. The other wire is
negative.
Note: It is sometimes difficult to distinguish wire
markings. Inspect both wires carefully.
1. Strip approximately '/2 in. (13 mm) of insulation from
both wires.
2. Twist the bare end of each wire so loose strands will
not touch across terminals.
Be sure to connect each wire to the proper speaker
terminal, positive to positive (+) and negative to
negative (-).
Note: For information on installing cable, consult
a
professional electrician
or
audio/video installer,
or
look
for reference books at
a
local home building retail store.
3