Bose 10.2 Stereo Everywhere 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Bose 10.2 Stereo Everywhere에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 10.2 Stereo Everywhere 29 페이지. Commercial sound system
Bose 10.2 Stereo Everywhere에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

DISASSEMBLY/ASSEMBLY PROCEDURES

102

Flush-Mount Loudspeaker

1. Grille Removal

1.1 The optional Bose

place via a tooth/groove-type design.

To remove the grille, grasp the edges of the

grille with your fingers and place your

thumbs toward the center of the grille.

1.2 As you press inward with your thumbs,

pull outward with your fingers. This will

release the teeth from the grooves, allow-

ing the grille to be removed from the loud-

speaker enclosure. (See Figure 1)

Figure 1. 102 Flush-Mount Grille Removal

2. Grille Replacement

2.1 Align the legs on the grille with the

openings in the speaker enclosure.

2.2 Press the grille upward so that the

teeth on the grille legs engage the teeth in

the speaker enclosure.

2.3 Push the grille upward until the

grille is flush with the mounting surface.

3. Driver Removal

3.1 Using a flat-blade screwdriver or a 1/4"

socket, remove the three screws holding

the driver in place.

grille is held in

3.2 Carefully lift the driver out of the enclo-

sure and cut the wires as close to the driver

terminals as possible.

4. Driver Replacement

4.1 Strip the wires and connect them to

the replacement driver. Make sure that

the red wire is connected to the

positive (+) terminal and the black wire

is connected to the negative (-) terminal

of the driver.

4.2 Align the driver and gasket to the

enclosure. Make certain the gasket is

correctly positioned to provide an airtight

seal.

4.3 Secure the driver to the enclosure with

the three screws. Do not overtighten.

(See Figure 2)

Figure 2. 102 Flush-Mount Driver

Replacement