Bose 10.2 Stereo Everywhere 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Bose 10.2 Stereo Everywhere에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 10.2 Stereo Everywhere 29 페이지. Commercial sound system
Bose 10.2 Stereo Everywhere에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: The following procedures are for the

transformered units only. The passive

versions do not have a tap selection switch

or transformer within the enclosure.

5. Baffle Removal

5.1 Remove the six screws (1) that hold

the baffle in place. Do not remove the

three screws holding the driver in place.

(See Figure 4)

5.2 Pry the baffle away from the enclosure

body. This can be accomplished by insert-

ing the hook portion of a scribe or your

fingers into the ports and using this as a

grasping area to pry the two sections apart.

This will expose the tap selection switch

and transformer.

6. Baffle Replacement

6.1 Align the port side of the baffle to the

side of the enclosure that has the input

terminals.

6.2 Secure the baffle with the six screws.

Figure 4. 102

Surface-Mount Baffle Assembly

102 System Controller Procedures

1. Top Cover Removal

Note: Refer to Figure 5, 102 System

Controller Exploded View.

1.1 Using a cross-tip screwdriver, remove

the six screws (1) securing the top cover,

(2) of the unit. There is one located on top,

two on the sides, and three on the back

panel.

1.2 Slide the top cover toward the rear of

the unit until it clears the ribs on the front

panel (3), then lift it straight off.

2. Top Cover Replacement

2.1 Align the top cover (2) with the rear

panel, and slide it down and forward until it

is in place against the front panel (3).

2.2 Secure the top cover using the six

screws (1) removed in procedure 1.1.

3. Front Panel Removal

3.1 Remove the top cover (2) using

procedures 1.1 and 1.2.

3.2 Turn the unit over, and remove the

three screws (4) that secure the front panel

(3) to the chassis (5).

3.3 Slide the front panel off of the chassis.

4. Front Panel Replacement

4.1 Slide the front panel (3) onto the

chassis (5), aligning the holes for the LEDs

and push-switch.

4.2 Secure the front panel to the chassis

using the three screws (4) removed in

procedure 3.2.

4.3 Replace the top cover (2) using

procedures 2.1 and 2.2.