Bose 10.2 Stereo Everywhere Servis Kılavuzu - Sayfa 8
Hoparlör Sistemi Bose 10.2 Stereo Everywhere için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Bose 10.2 Stereo Everywhere 29 sayfaları. Commercial sound system
Ayrıca Bose 10.2 Stereo Everywhere için: Kullanıcı El Kitabı (8 sayfalar)
Sayfayı YazdırDISASSEMBLY/ASSEMBLY PROCEDURES
Note: The following procedures are for the
transformered units only. The passive
versions do not have a tap selection switch
or transformer within the enclosure.
5. Baffle Removal
5.1 Remove the six screws (1) that hold
the baffle in place. Do not remove the
three screws holding the driver in place.
(See Figure 4)
5.2 Pry the baffle away from the enclosure
body. This can be accomplished by insert-
ing the hook portion of a scribe or your
fingers into the ports and using this as a
grasping area to pry the two sections apart.
This will expose the tap selection switch
and transformer.
6. Baffle Replacement
6.1 Align the port side of the baffle to the
side of the enclosure that has the input
terminals.
6.2 Secure the baffle with the six screws.
Figure 4. 102
®
Surface-Mount Baffle Assembly
102 System Controller Procedures
1. Top Cover Removal
Note: Refer to Figure 5, 102 System
Controller Exploded View.
1.1 Using a cross-tip screwdriver, remove
the six screws (1) securing the top cover,
(2) of the unit. There is one located on top,
two on the sides, and three on the back
panel.
1.2 Slide the top cover toward the rear of
the unit until it clears the ribs on the front
panel (3), then lift it straight off.
2. Top Cover Replacement
2.1 Align the top cover (2) with the rear
panel, and slide it down and forward until it
is in place against the front panel (3).
2.2 Secure the top cover using the six
screws (1) removed in procedure 1.1.
3. Front Panel Removal
3.1 Remove the top cover (2) using
procedures 1.1 and 1.2.
3.2 Turn the unit over, and remove the
three screws (4) that secure the front panel
(3) to the chassis (5).
3.3 Slide the front panel off of the chassis.
4. Front Panel Replacement
4.1 Slide the front panel (3) onto the
chassis (5), aligning the holes for the LEDs
and push-switch.
4.2 Secure the front panel to the chassis
using the three screws (4) removed in
procedure 3.2.
4.3 Replace the top cover (2) using
procedures 2.1 and 2.2.
8