Bose 301 Series V 사용자 설명서 - 페이지 3

{카테고리_이름} Bose 301 Series V에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose 301 Series V 10 페이지. Direct/reflecting speakers
Bose 301 Series V에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지), 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (12 페이지), 소유자 매뉴얼 (21 페이지), 소유자 매뉴얼 (13 페이지), 소유자 매뉴얼 (16 페이지)

페이지 인쇄

DISASSEMBLY/ASSEMBLY PROCEDURES

Note: Refer to figure 3 for the following

procedures.

1. Grille Removal

1.1 Grasp the top and bottom edges of the

grille (12) and pull off the grille.

2. Grille Replacement

2.1 Align the grille (12) so that the Bose

logo (11) is right side up on the tweeter

side of the cabinet and push it into place.

3. Woofer Removal

3.1 Perform procedure 1.

3.2 Remove the four screws (13) that

secure the woofer (14) to the cabinet.

3.3 Lift the woofer out and cut the wires as

close to the terminals as possible.

4. Woofer Replacement

4.1 Strip the wires and connect the wires as

shown in figure 1. The red wire to the single

center terminal. The black wire to the right

side double terminal (looking at the woofer

magnet side down). The orange and green

wires to the left double terminal. The

capacitor is connected to the far left and

right terminals.

4.2 Secure the woofer (14) to the cabinet

using four screws (13).

4.3 Perform procedure 2.

5. Front Tweeter Removal

5.1 Perform procedures 1, 3.2 and lift the

wooter out of the cabinet, but do not cut the

wires.

5.2 Using a 1/4 inch socket, remove the

screw (6) and bracket (7) that secures the

tweeter (8) to the cabinet.

5.3 Lift the tweeter out of the cabinet and

cut the wires as close to the terminals as

possible.

6. Front Tweeter Replacement

6.1 Strip the wires and connect the red

wire to the positive (+) terminal and the

black wire to the negative (-) terminal.

Dress or twist the wires to prevent buzzes.

6.2 Place the tweeter (8) into the cabinet

and secure it using the tweeter bracket (7)

and screw (6).

6.3 Perform procedures 4.2 and 2.

7. Rear Tweeter Removal

7.1 Perform procedures 1, 3.2 and lift the

woofer out of the cabinet, but do not cut the

wires.

7.2 Using a 1/4 inch wrench, remove the

screw (1) and bracket (2) that secures the

tweeter (3) to the cabinet.

7.3 Lift the tweeter out of the cabinet and

cut the wires as close to the terminals as

possible.

orange

green

Figure 1. Woofer Wiring Configuration

red

black