Bose Acoustimass 10 Series I 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Bose Acoustimass 10 Series I에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 10 Series I 18 페이지. Series 2
Bose Acoustimass 10 Series I에 대해서도 마찬가지입니다: 소유자 매뉴얼 (25 페이지), 소유자 매뉴얼 (17 페이지), 매뉴얼 (17 페이지)

페이지 인쇄

For realistic home theater sound

Each speaker produces only the sound directed to it by the steering logic in your surround

sound receiver. During a surround sound program the front and center speakers will emit

sound almost constantly, while the surround speakers may be silent for periods of time.

How to set your Pro-Logic receiver

You must set the volume levels for the front, center, and surround speakers at your receiver.

For use in video applications, be sure the SURROUND SOUND center mode setting of your

receiver is on NORMAL (Figure 10). The center channel and surround (rear) speakers have a

wider response range and therefore play at a slightly lower volume. The signal levels for

these speakers may need to be increased. You can adjust these levels at the receiver or

with the remote control. Your receiver may have a test tone to help you set volume levels.

If it does, follow these steps:

•

Press test tone ON at the remote.

•

Set the volume for the speakers in the following order: Left, Center, Right, Surround.

•

Balance the pink noise tone for evenness among all individual speakers.

Instructions for this process vary, depending on the brand and model of receiver you are

using. Follow your receiver owner's guide for testing and adjusting the balance of each

speaker.

Bass and treble adjustments

Upholstered furniture, wall-to-wall carpets, or heavy drapes can muffle treble (high notes),

making your speaker system sound bass heavy. Bare floors and walls and hard surface

furniture can make your speaker system sound too shrill. After listening to your speakers,

you may want to adjust the balance of bass and treble. You can use the bass and treble

controls on your receiver.

Set your Dolby AC-3 receiver correctly

Your Acoustimass-10 speakers are compatible with the output from Dolby AC-3 receivers.

Take special care to set the channel output according to the specifications listed in the chart

below. The cube speakers are full-range loudspeakers and must be set up as LARGE

speakers on the AC-3 screen menu. An exception is the center speaker, which must be set

as SMALL. Turn the subwoofer OFF. Finally, turn the LFE (low frequency effects) ON and set

the crossover frequency to 200Hz.

Speaker

Left and Right Front .......................... Large

Center ............................................... Small

Left and Right Surround ................... Large

Subwoofer ........................................ OFF (not used)

LFE (low frequency effects) .............. ON

Crossover frequency ........................ 200Hz

AM183644_01_V.pdf

Using Your Acoustimass

14 15 16 17

Setting at receiver

December 20, 2001

-10 Speakers

Figure 10

A Dolby Pro-Logic receiver set

for NORMAL surround sound