Bose Acoustimass 15 Series II 사용자 설명서 - 페이지 13
{카테고리_이름} Bose Acoustimass 15 Series II에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 15 Series II 18 페이지. Home entertainment speaker systems
Bose Acoustimass 15 Series II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 빠른 설정 매뉴얼 (1 페이지), 매뉴얼 (24 페이지)
페이지 인쇄
For realistic
home
theater
sound
CAUTION: The AcoustimasJ '_75 Series II and Acoustimass
76 speaker systems incorporate
an automatic protection circuit, which guards against most kinds of damage from electrical
stress or overload. This circuit activates at high volume levels to reduce output, causing a
slight decrease in volume. This is normal operation and indicates that power input may be
exceeding safe levels. Sustained listening at these levels is not recommended.
Adjusting
the LFE level
The LFE (low-frequency
effects) level control on your powered Acoustimass
module
increases or decreases the relative level of low-frequency
effects on movie sound tracks. Use
it to regulate the presence of these underlying deep bass sounds. Use the "test tones" feature
in your digital surround sound receiver to match the volume levels for each of the cube
speakers. Then use the LFE control on the Acoustimass
module to match the volume of the
LFE channel to the cube speaker channels.
Adjusting
the bass/room
compensation
level
This feature will allow you to fine-tune your system after you have placed the Acoustimass
module in your selected location. If the room sounds "thin" or lacks bass, turn the BASS con-
trol in a clockwise direction to increase the bass level of the module. If the room sounds
"boomy"
or has too much bass, turn the knob in a counter-clockwise
rotation to reduce the
bass level of the module. The factory or detent setting is appropriate for a majority of listening
situations.
Setting
your
digital
surround
sound
receiver
Your Acoustimass
16 or Acoustimass
15 Series II speakers are fully compatible
with the
output from digital surround receivers. Integrated Signal Processing assures full bass
reproduction
for all channels regardless of receiver settings. However, the following table
suggests a set of recommended
receiver settings. The cube speaker arrays should be set to
LARGE in the receiver's digital display menu. The LFE, or subwoofer, is set to ON. If applica-
ble, the crossover value should be set to the lowest number possible, typically 80 Hz.
Speaker
Receiver
setting
Left and right
LARGE
Center
LARGE
Left and right surround
LARGE
Center surround*
LARGE
LFE/Subwoofer
ON
*Applies to Acoustimass
16 systems or upgraded Acoustimass
15 Series II systems. For upgrade
information, see "Upgrading your Acoustimass
15 Series II speaker system" on page 12.
AM264924_00 _ V.pdf • August 13, 2002
13