Bose CineMate GS Series II 소유자 매뉴얼 - 페이지 20

{카테고리_이름} Bose CineMate GS Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose CineMate GS Series II 50 페이지. Digital home theater speaker system
Bose CineMate GS Series II에 대해서도 마찬가지입니다: 코드 목록 (28 페이지), 빠른 설정 매뉴얼 (2 페이지), 소유자 매뉴얼 (38 페이지), (영어) 사용자 가이드 (32 페이지)

페이지 인쇄

ONTROLS AND

NDICATORS

Using the remote to control the

CineMate

system

When you point the remote control at the interface

module and press the On-Off, Volume, or Mute button,

the green LED on the interface module flashes.

Press On-Off to turn on the CineMate

speaker system. Press again to turn the

system off.

Press Volume Up to raise the volume. When

maximum volume is reached, the green LED

on the interface module flashes twice.

Press Volume Down to reduce the volume.

When the minimum volume is reached, the

green LED on the interface module flashes

twice.

Press Mute to silence the audio. Press

again to restore the audio. When the system

is muted, the green LED on the interface

module flashes until audio is restored.

The universal remote can also be programmed to

control up to five audio/video devices and will control

the functions of one device at a time.

Svenska

Nederlands

Setting the remote for your TV and other

devices

To use the remote with your TV, you must set the

remote for the proper TV device code.

1. Locate the TV section in the Universal Remote

Device Codes book.

2. Locate the device code(s) for your brand of TV and

start with the first one.

3. Press and hold Setup on the remote until all five

source buttons light up.

4. Press the TV source button. Only the TV source

button will remain lit.

5. On the remote keypad, enter the first device code

for your brand of TV.

6. Check that the TV source button blinks twice and

turns off after the code is entered.

7. Point the remote at your TV and press TV On-Off.

If your TV does not respond, go back to Step 1 and

try another code.

Note: During programming, the five source buttons will

flash rapidly three times if you press an invalid key or enter

an unavailable device code. If this happens, go back to

Step 1 and start over.

Français

Italiano

Deutsch

Español

English