ABSCO SHEDS CPSW50 조립 및 사용 설명서 - 페이지 14

{카테고리_이름} ABSCO SHEDS CPSW50에 대한 조립 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABSCO SHEDS CPSW50 18 페이지. Skillion carport

STEP 10

BEND THE ENDS OF 16 FLAT STRIPS (270mm X 25mm) AS

SHOWN AND SECURE AT MAXIMUM

1500mm CENTRES WITH ONE

SCREW AT EACH END.

DP-5

DP-3

CUT A ROUND HOLE 51mm IN DIAMETER

IN ONE END OF THE REAR EDGE BEAM. THIS

CAN BE DONE BY DRILLING A SERIES OF 3mm HOLES

AND THEN PUNCHING OUT THAT SECTION. FIT THE GALVANISED GUTTER DROP AND SEAL WITH

SILICONE. FASTEN THE DOWNPIPES AND BENDS AS SHOWN. BEND THE 270 x 25 FLAT STRIPS

(DS) TO SHAPE AND FASTEN THE DOWNPIPE TO THE COLUMNS.

IMMEDIATE MAINTENANCE:

CLEAN DOWN ALL ROOF AND EDGE/CROSS BEAM INTERNAL AREAS. METAL FILINGS FROM

DRILLING HOLES AND USING SELF DRILLING SCREWS CAN CAUSE DISCOLORATION AND

CORROSION TO ROOF SHEETS AND GALVANIZED FRAMING SECTIONS.

ABSCO INDUSTRIES

Skillion Carport Model: CPSW50

DP-2

DP-1

DP-4

ASSEMBLY INSTRUCTION MANUAL

Absco Industries

CARPORT MODEL: CPSW50

10-05-2017

PAGE 14