3M G5 매뉴얼 - 페이지 7

{카테고리_이름} 3M G5에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M G5 10 페이지. Drive-thru systems
3M G5에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 기술 게시판 (6 페이지), 기술 게시판 (2 페이지), 빠른 시작 매뉴얼 (3 페이지), 기술 게시판 (12 페이지), 매뉴얼 (8 페이지)

5. Timer Greet Event.

Currently The Greet Event (for a Timer) is extracted from the XT-1 Basestation using any one of the following procedures.

a. Using

and GND on the XT-1 Basestation

b. Using a combination of XT-1 Basestation's

-- 3

Detector Relay on top of the XT-1 Basestation and

-- The Auxiliary Relay #3 and it's COM

c. Using XT-1 Basestation's Menu Board Speaker terminals (MEN SKR+ and MEN SKR-)

To extract the Greet Event from the G5 Basestation, connect the wires from the Timer system to GPIO11 and GND1 as illustrated.

NOTE: GENERAL PURPOSE INPUT / OUTPUTs (GPIOs):

The G5 Basestation provides 16 configurable logical Inputs and Outputs.

All Inputs and Outputs are Active Low and are factory set to the following signals.

You can reassign any of these GPIOs to output or take as input a different signal via Digital IO Setup in the System Menu

and GND

To Timer System