Bose Acoustimass 3 Series 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Bose Acoustimass 3 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 3 Series 17 페이지. Powered speaker system
Bose Acoustimass 3 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (10 페이지), 서비스 매뉴얼 (42 페이지), 매뉴얼 (43 페이지)

페이지 인쇄

Selecting a location for the Acoustimass

Figure 2

Choices on how to position the

module

Using the cables correctly

AM252171_02_V.pdf

Setting Up Your Acoustimass

The Acoustimass module can be hidden almost anywhere in a room. Leave at least 2 inches

(5 cm) of space between the opening (port) and the wall. To prevent interference, keep the

module at least 2 feet (0.6 m) from any video screen.

For a balanced sound in most rooms, place the module along a wall within 5 feet (1.5 m) of the

corner. To increase bass response, move the module closer to a corner without blocking the

opening. To decrease the bass, place the module farther from the corner.

Note: When you decide how you will position the module, attach the rubber feet to the

bottom surface to protect the module and the floor.

Use the supplied cables to connect the cube speakers to the module and the module to your

amplifier or receiver.

CAUTION: Be sure all components are turned off and unplugged from the power outlet

before making the connections.

To place these components more than 20 feet (6.2 - 9.2 m) apart, you will need to splice in a

length of 18-gauge speaker cable. To place them more than 30 feet (9.2 m) apart, you will

need heavier gauge wire. (See the wire recommendations on page 10.) You can get additional

speaker cable at electrical and hardware stores or by calling Bose Customer Service. (See

the list of phone numbers inside the back cover.)

Speaker cables consist of two insulated wires. The insulation around one wire is marked with

a band or stripe. This marked wire is always positive (+). The plain wire is always negative (–).

These correspond to the red (+) and black (–) terminals on the back of the speaker, amplifier,

or receiver. Be sure to connect each wire to the proper terminal (positive to positive, negative

to negative).

October 22, 2001

module

3 Speaker System