Bose Acoustimass 3 Series 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Bose Acoustimass 3 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 3 Series 17 페이지. Powered speaker system
Bose Acoustimass 3 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (10 페이지), 서비스 매뉴얼 (42 페이지), 매뉴얼 (43 페이지)

페이지 인쇄

Setting Up Your Acoustimass

Connecting the cube speakers to the Acoustimass

Figure 3

Connecting the speaker cable

to the cube speaker

Connecting the Acoustimass module to your receiver or amplifier

3 Speaker System

Use the following steps to connect the cube speakers to the rear panel of the Acoustimass

module:

1. Select one pair of wires, and locate the terminal tab on the rear of the left cube speaker.

2. Press the terminal tab on the back of the speaker and insert the marked wire into the red

(+) terminal and the plain wire into the black (–) terminal (Figure 3).

3. Release the terminal tab to secure both wires.

4. Repeat this process with the other pair of wires and the right cube speaker.

CAUTION: Do not connect your amplifier or receiver directly to the cube speakers. Cube

speakers must be connected directly to the Acoustimass module or damage will result.

5. Locate the terminals marked OUTPUTS TO CUBE SPEAKERS on the rear panel of the

Acoustimass module (Figure 4).

6. Connect the free end of the left cube speaker cable to the left (L) pair of terminals. Make

sure that the marked wire is connected to the positive (+) terminal and the plain wire is

connected to the negative (–) terminal.

7. Repeat step 6 for the right cube speaker cable, connecting its wires to the right (R) pair of

terminals.

Use the following steps to connect your Acoustimass module to your receiver or amplifier:

CAUTION: Correct wiring is important. Incorrect wiring will result in little or no bass output

and could potentially damage the system.

1. Locate the terminals marked INPUTS FROM AMP OR RECEIVER on the rear panel of the

Acoustimass module (Figure 4).

2. Connect either end of one of the remaining speaker cables to the left (L) pair of input

terminals. Make sure that the marked wire is connected to the positive (+) terminal and the

plain wire is connected to the negative (–) terminal.

3. Connect either end of the final speaker cable to the right (R) pair of input terminals. Make

sure that the marked wire is connected to the positive (+) terminal and the plain wire is

connected to the negative (–) terminal.

October 22, 2001

module

AM252171_02_V.pdf