Bose ControlSpace AMS-8 소프트웨어 설명서 - 페이지 10

{카테고리_이름} Bose ControlSpace AMS-8에 대한 소프트웨어 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose ControlSpace AMS-8 32 페이지. Audio management system
Bose ControlSpace AMS-8에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

1. ControlSpace

AMS-8 LIvE Installer Software

™

1.3.2 Graphic EQ

change the Maximum volume level (between -82dB & +18dB) of the selected output/room

change the Paging level (between -82dB & +18dB) of the selected output/room.

The paging level can exceed the maximum volume level of the selected output/room

adjust the Bass and Treble level (between -15dB & +15dB) of the selected output/room

set the Delay of the selected output/room in steps of 0.05ms, up to a maximum of 10ms

Note: Dynamic EQ is used to maintain a good tonal balance at all listening levels. To make sure

the Dynamic EQ operates in the best way, one should make sure all the input levels are set at 0dB

(see chapter 1.2.3.) and that the connected amplifier can be fully driven when 0dB of audio signal is

applied to the amplifier, coming from the AMS-8 system.

Maximum Operation

Dynamic EQ

Minimum Operation

-60dB

Output Level

When the lower ❑ button is pressed and the Graphic EQ (GEQ) is selected, below module is opened.

With this module one can change the Room EQ using 16 frequency bands, Each frequency band can be

changed between -12dB & +12dB. Once a Graphic EQ has been set, one is able to save these GEQ settings

so they can be used for another output/room in the same or another project.

Press or use the following buttons or faders to:

save the Graphic EQ settings

reset all faders back to the 0dB position

load a Graphic EQ file

0dB