Bose ControlSpace AMS-8 Yazılım Kılavuzu - Sayfa 10
Stereo sistemi Bose ControlSpace AMS-8 için çevrimiçi göz atın veya pdf Yazılım Kılavuzu indirin. Bose ControlSpace AMS-8 32 sayfaları. Audio management system
Ayrıca Bose ControlSpace AMS-8 için: Kullanıcı Kılavuzu (16 sayfalar)
Sayfayı Yazdır
1. ControlSpace
AMS-8 LIvE Installer Software
™
1.3.2 Graphic EQ
10
change the Maximum volume level (between -82dB & +18dB) of the selected output/room
change the Paging level (between -82dB & +18dB) of the selected output/room.
The paging level can exceed the maximum volume level of the selected output/room
adjust the Bass and Treble level (between -15dB & +15dB) of the selected output/room
set the Delay of the selected output/room in steps of 0.05ms, up to a maximum of 10ms
Note: Dynamic EQ is used to maintain a good tonal balance at all listening levels. To make sure
the Dynamic EQ operates in the best way, one should make sure all the input levels are set at 0dB
(see chapter 1.2.3.) and that the connected amplifier can be fully driven when 0dB of audio signal is
applied to the amplifier, coming from the AMS-8 system.
Maximum Operation
Dynamic EQ
Minimum Operation
-60dB
Output Level
When the lower ❑ button is pressed and the Graphic EQ (GEQ) is selected, below module is opened.
With this module one can change the Room EQ using 16 frequency bands, Each frequency band can be
changed between -12dB & +12dB. Once a Graphic EQ has been set, one is able to save these GEQ settings
so they can be used for another output/room in the same or another project.
Press or use the following buttons or faders to:
save the Graphic EQ settings
reset all faders back to the 0dB position
load a Graphic EQ file
0dB