Bose SoundTouch 서비스 매뉴얼 - 페이지 31

{카테고리_이름} Bose SoundTouch에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose SoundTouch 39 페이지. Wireless pedestal
Bose SoundTouch에 대해서도 마찬가지입니다: 소유자 매뉴얼 (33 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (2 페이지), 매뉴얼 (9 페이지), 소유자 매뉴얼 (20 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (5 페이지), 여기에서 시작하기 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (2 페이지), 소유자 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

DISASSEMBLY PROCEDURES

Note: Refer to the figure below for the

following procedures.

1. Top Cover Removal

1.1 With the unit upside down, remove the

six screws (15) on the bottom of the unit that

secure the top cover (1) to the base (2).

1.2 Turn the unit back over and lift off the top

cover.

Note: Service replacement top covers

include the front bezel that is adhered to the

front of the top cover. The part number is

located on the main parts list.

2. Input/Output PCB Assembly Removal

2.1 Perform procedure 1.

2.2 Disconnect the Bose

J201 on the I/O PCB (8). Disconnect the two

ribbon cables (6,17) at J200 and J300 that

run to the Wi-Fi Module PCB (7).

2.3 Remove the two screws that secure the

I/O PCB assembly to the base. Lift out the

I/O PCB assembly.

Link cable (4) from

5x 3

4x 9

Note: Be sure to retain the scrims that

cover the connectors and the reset button

from the old I/O PCB for re-use.

3. Wi-Fi Module PCB Removal

3.1 Perform procedure 1.

3.2 Disconnect the two ribbon cables (6,17)

at J1203 and J1201 that run to the I/O PCB

(8) assembly.

3.3 Remove the three screws that secure

the Wi-Fi PCB (7) assembly to the base.

Lift out the Wi-Fi PCB.

4. Enclosure Base Removal

4.1 Perform procedure 1.

4.2 Remove the I/O (8) and Wi-Fi Module

PCB (7) assemblies using procedures 2

and 3. You can now replace the base (2).

Note: The Service replacement enclosure

base is supplied with the Bose Link cable,

rear panel I/O label and feet attached as a

Service subassembly. Refer to the main

parts list for the part number.

15 6x