Bose PM8500 사용자 설명서 - 페이지 31

{카테고리_이름} Bose PM8500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose PM8500 44 페이지. Configurable professional power amplifier
Bose PM8500에 대해서도 마찬가지입니다: 기술 데이터 시트 (6 페이지), 설치 및 안전 매뉴얼 (21 페이지)

페이지 인쇄
Bose PM8500 사용자 설명서
pro.bose.com
UTILITY
Standby Mode
➞
Alarm Log
Network Setup (Device ID)
Lock Front Panel
Set Front Panel Lock Combination
Display
Restore Factory Settings
Firmware Version
Description
Available Controls
Options
Notes
UTILITY
Standby Mode
Alarm Log
➞
Network Setup (Device ID)
Lock Front Panel
Set Front Panel Lock Combination
Display
Restore Factory Settings
Firmware Version
Description
Available Controls
Options
UTILITY
Standby Mode
Alarm Log
➞
Network Setup (Device ID)
Lock Front Panel
Set Front Panel Lock Combination
Display
Restore Factory Settings
Firmware Version
Description
Available Controls
Options
English
MAIN MENU < UTILITY < ALARM LOG
This display allows you to view, clear, and erase captured alarm notifications.
To access ALARM LOG, use the rotary encoder dial from the DSP menu to highlight, then press to select.
Navigation Soft Key: Back to UTILITY menu.
Menu Soft Key #5: Enables the rotary encoder dial to scroll through the alarm log.
Menu Soft Key #1: Clears the alarm indicated by the FAULT LED on the front panel.
Menu Soft Key #3: Erases all entries captured in the alarm log. A confirmation screen is presented by which users can confirm (Soft
Key #1) or cancel (Soft Key #5).
Exit Standby, Enter Standby
ControlSpace Designer software allows you to configure and view additional information about alarm and fault conditions.
MAIN MENU < UTILITY < NETWORK SETUP (PM8500N only)
This display allows you to set the network IP address of the PM8500N amplifier.
To access Network Setup, use the rotary encoder dial from the DSP menu to highlight, then press to select.
Navigation Soft Key: Back to UTILITY menu.
Menu Soft Key #1: Enables the rotary encoder dial to toggle between DHCP or FIXED IP address mode. Push the rotary encoder
to enable the selection. A confirmation screen is presented by which users can confirm (Soft Key #1) or cancel (Soft Key #5). Upon
confirmation, the unit will save and reboot using the new setting.
Menu Soft Key #2-5: Enables the rotary encoder dial to adjust the value of each IP address octet. Once the IP address has been fully
modified, push the rotary encoder to enable the selection. A confirmation screen is presented by which users can confirm (Soft Key
#1) or cancel (Soft Key #5). Upon confirmation, the unit will save and reboot using the new setting.
Mode: DHCP, Fixed
IP Address Octet Values: 0 to 255
MAIN MENU < UTILITY < DEVICE ID (PM8500 only)
This display allows you to set the device identification number of the PM8500 amplifier.
To access Network Setup, use the rotary encoder dial from the DSP menu to highlight, then press to select.
Navigation Soft Key: Back to UTILITY menu.
Rotary Encoder: Use the dial to scroll through device ID values. Push the rotary encoder to set the new device ID. A confirmation
screen is presented by which users can confirm (Soft Key #1) or cancel (Soft Key #5).
Device ID Number: 1-255
User guide
User Guide Page 31