Bose SoundTouch SA-4 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Bose SoundTouch SA-4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose SoundTouch SA-4 42 페이지. Amplifier
Bose SoundTouch SA-4에 대해서도 마찬가지입니다: 매뉴얼 (34 페이지), 소유자 매뉴얼 (36 페이지)
페이지 인쇄
Setting up the System
Connecting speakers to the SA-4 amplifier
CAUTIONS:
Use only unpowered speakers. DO NOT connect any make or model of
powered speakers. Doing so may cause damage to the equipment.
The SoundTouch
SA-4 amplifier requires a 6-ohm minimum load.
™
Speaker cables consist of two insulated wires. Often, one wire is marked (striped,
colored, or ribbed), indicating it should be connected to the positive (+) terminal.
The plain wire should be connected to the negative (–) terminal. For recommended
wire sizes and lengths, see "Speaker cable recommendations" on page 27.
1.
Disconnect the SA-4 amplifier from AC (mains) power.
2.
Remove the terminal block connector from the SPEAKER OUTPUTS
connector on the rear panel of the SA-4 amplifier.
3.
Use a small, flat-head screwdriver to connect the left speaker cable to the
L positive (+) and minus (–) terminals of the 4-pin terminal block connector,
and the right speaker cable to the R positive (+) and minus (–) terminals.
Bose 251
®
shown for illustration only.
4.
Plug the terminal block connector into the SPEAKER OUTPUTS connector.
14 - English
Environmental Speakers