Bose SoundTouch SA-4 Gebruikershandleiding - Pagina 14
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Bose SoundTouch SA-4. Bose SoundTouch SA-4 42 pagina's. Amplifier
Ook voor Bose SoundTouch SA-4: Handmatig (34 pagina's), Gebruikershandleiding (36 pagina's)
Pagina afdrukken
Setting up the System
Connecting speakers to the SA-4 amplifier
CAUTIONS:
Use only unpowered speakers. DO NOT connect any make or model of
powered speakers. Doing so may cause damage to the equipment.
The SoundTouch
SA-4 amplifier requires a 6-ohm minimum load.
™
Speaker cables consist of two insulated wires. Often, one wire is marked (striped,
colored, or ribbed), indicating it should be connected to the positive (+) terminal.
The plain wire should be connected to the negative (–) terminal. For recommended
wire sizes and lengths, see "Speaker cable recommendations" on page 27.
1.
Disconnect the SA-4 amplifier from AC (mains) power.
2.
Remove the terminal block connector from the SPEAKER OUTPUTS
connector on the rear panel of the SA-4 amplifier.
3.
Use a small, flat-head screwdriver to connect the left speaker cable to the
L positive (+) and minus (–) terminals of the 4-pin terminal block connector,
and the right speaker cable to the R positive (+) and minus (–) terminals.
Bose 251
®
shown for illustration only.
4.
Plug the terminal block connector into the SPEAKER OUTPUTS connector.
14 - English
Environmental Speakers