AirTek TW55 설치, 운영 및 유지보수 매뉴얼 - 페이지 14
{카테고리_이름} AirTek TW55에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTek TW55 20 페이지. Heatless desiccant compressed air dryer
페이지 인쇄16. A. Sequence of Operation Diagram
RECOMMENDED INSTALLATION
CLEAN DRY, CONTAMINANT FREE AIR
NOTES:
1. By-Pass Piping should be installed around filters and dryer
for servicing.
2. Differential pressure indicators should be installed on filters
for monitoring of elements
3. Coalescing Prefilter & Particulate Afterfilter are required.
Particulate filter before dryer and adsorber after dryer are
optional.
4. Auto drains must be installed on separator, air receiver,
prefilter & coalescer.
5. Location of receiver may vary depending on particular
conditions & type of compressor. Auto drain required when
receiver is mounted upstream of dryer.
6. Locate coalescing filter as close to dryer as possible.
WARNING: INCORRECT INSTALLATION WILL VOID WARRANTY
- COALESCING PREFILTER W/ AUTO DRAIN MUST BE INSTALLED
- DRYERS ARE DESIGNED FOR 100ºF INLET TEMPERATURE
- DRYER SHOULD BE LOCATED IN AN AREA ACCESSIBLE FOR MAINTENANCE
- AMBIENT TEMP. SHOULD BE BETWEEN 35ºF & 100ºF
- LOCATION SHOULD BE CLEAN, COOL, w/ A LEVEL, VIBRATION FREE FLOOR.
AIRTEK
4087 WALDEN AVENUE, LANCASTER, NY 14086
(Note: Desiccant Dryers are designed to remove water VAPOR only)
(Liquid water and oil will damage desiccant)
KEY:
AD =
AUTOMATIC DRAIN
F
=
PARTICULATE FILTER
C =
COALESCING FILTER
A =
ADSORBING FILTER
T
=
TEMPERATURE INDICATOR
D =
DEWPOINT INDICATOR/CONTROLLER
=
DIFFERENTIAL PRESSURE INDICATOR
Tel: (716) 685-4040
Pg. -14-
DWG AT718
Rev. C
1/15/92
Fax: (716) 685-1010