AirTek TW55 Kurulum, Çalıştırma ve Bakım Kılavuzu - Sayfa 14
Nem Alıcı AirTek TW55 için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Bakım Kılavuzu indirin. AirTek TW55 20 sayfaları. Heatless desiccant compressed air dryer
Sayfayı Yazdır16. A. Sequence of Operation Diagram
RECOMMENDED INSTALLATION
CLEAN DRY, CONTAMINANT FREE AIR
NOTES:
1. By-Pass Piping should be installed around filters and dryer
for servicing.
2. Differential pressure indicators should be installed on filters
for monitoring of elements
3. Coalescing Prefilter & Particulate Afterfilter are required.
Particulate filter before dryer and adsorber after dryer are
optional.
4. Auto drains must be installed on separator, air receiver,
prefilter & coalescer.
5. Location of receiver may vary depending on particular
conditions & type of compressor. Auto drain required when
receiver is mounted upstream of dryer.
6. Locate coalescing filter as close to dryer as possible.
WARNING: INCORRECT INSTALLATION WILL VOID WARRANTY
- COALESCING PREFILTER W/ AUTO DRAIN MUST BE INSTALLED
- DRYERS ARE DESIGNED FOR 100ºF INLET TEMPERATURE
- DRYER SHOULD BE LOCATED IN AN AREA ACCESSIBLE FOR MAINTENANCE
- AMBIENT TEMP. SHOULD BE BETWEEN 35ºF & 100ºF
- LOCATION SHOULD BE CLEAN, COOL, w/ A LEVEL, VIBRATION FREE FLOOR.
AIRTEK
4087 WALDEN AVENUE, LANCASTER, NY 14086
(Note: Desiccant Dryers are designed to remove water VAPOR only)
(Liquid water and oil will damage desiccant)
KEY:
AD =
AUTOMATIC DRAIN
F
=
PARTICULATE FILTER
C =
COALESCING FILTER
A =
ADSORBING FILTER
T
=
TEMPERATURE INDICATOR
D =
DEWPOINT INDICATOR/CONTROLLER
=
DIFFERENTIAL PRESSURE INDICATOR
Tel: (716) 685-4040
Pg. -14-
DWG AT718
Rev. C
1/15/92
Fax: (716) 685-1010