Beckman Coulter Cytomics FC 500 사용자 설명서 - 페이지 6

{카테고리_이름} Beckman Coulter Cytomics FC 500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Beckman Coulter Cytomics FC 500 14 페이지. With cxp software
Beckman Coulter Cytomics FC 500에 대해서도 마찬가지입니다: 시작하기 (20 페이지)

페이지 인쇄

Running Tubes

A. Single Tube Mode allows the user to place one tube at a time onto the carousel. The

sample is run, then the instrument stops & returns the tube. The first tube must be

removed and then another tube can be loaded in the same position. All tubes are

placed in position 10 of the carousel, which can be accessed by the small Tube

Access door on the front of the carousel lid when the instrument is in Single Tube

mode. When in Single Tube mode, the lid of the carousel should not be opened.

1. Adjust the Workspace Preferences, if needed, to produce the desired naming

and printing results.

2. Click on the Single Tube button

3. Lift the Tube Access door, insert tube, and close door.

4. Click on the Run button

i. While running, voltages and compensation values can be altered from

the Detectors and Compensation tabs, respectively, on the

Cytometer Controls window, accessed by the button on the toolbar or

by clicking Cytometer then Cytometer Controls.

ii. If setting up a new protocol, it is advisable to alter the

voltages/compensation under Setup mode, which can be activated

through a checkbox in the Parameters tab of Cytometer Controls.

5. After starting the run, the software will display a series of messages at the

bottom of the screen: Awaiting Sample, Preparing Sample, Acquiring, and

Stopping. When complete, the tube will return to the Tube Access door and

the software will display the Awaiting Sample message.

in the toolbar.