Absima SR2S 사용 설명서 - 페이지 7

{카테고리_이름} Absima SR2S에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Absima SR2S 10 페이지. 2.4ghz 2 channel radio control system

It use digital transmission mode, and this prevent outside interference effective

active and passive.

9.01 Matching (code)

Our products are well matched in the factory, you don´t need to match by yourself. If you

are going to match the receiver with another transmitter or you have to connect a new

receiver or transmitter, please follow the following steps:

1. Install the battery to the 2.4GHz transmitter and shut it down.

2. Insert the matching lines to the channel „BIND/VCC" port of the receiver.

3. Switch on the ESC or connect a receiver battery to channel 3, at the same time the red

LED is ﬂashing and this means the receiver is in the BIND mode.

4. Press and hold the „BIND" button on the transmitter and switch on the power supply.

5. Observe the LED on the receiver. If the LED stops ﬂashing, the binding process was

successful.

6. Release the „BIND" button on the transmitter and take out the matching line.

7. Install the servo for testing

8. If the test fails, please repeat the action above.

BIND button

9.02 Switch on

1. Connect every servo.

2. Switch on the transmitter.

3. Switch on the ESC or power supply.

4. Receiver LED light solid.

5. Finish and use.

9. 2.4GHz Operation notes

2.4GHz 2 Channel remote system

Model: SR2S