Elektra Beckum SKN 50 운영 및 유지보수 지침 매뉴얼 - 페이지 4
{카테고리_이름} Elektra Beckum SKN 50에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Elektra Beckum SKN 50 8 페이지. Elektra beckum finish nailer operating and maintenance instructions
Elektra Beckum SKN 50에 대해서도 마찬가지입니다: (사용자 및 유지 관리 매뉴얼 (8 페이지)
페이지 인쇄
Contents
1. Getting to Know Your
Finish Nailer SKN 50
2. Please Read First!
2.1 Specified conditions of
use
3. Safety Instructions
3.1 Regulations
3.2 Tool safety
3.3 Work safety
4. Initial Operation
5. Care and Maintenance
5.1 Care
5.2 Trouble shooting
6. Specifications
7. Standard Delivery
8. Accessories
2. Please Read First
Read instructions before
commissioning, especi-
ally the safety instructions.
If you notice transport
damage while unpacking,
notify
your
supplier
immediately. Do not
operate the air tool!
Dispose of the packing in
an environmentally friend-
ly manner. Take to a pro-
per collecting point.
Keep instructions for
future use.
If you lend or sell this air
tool be sure to have the
instructions to go with it.
2.1 Specified conditions of
use
This Finish Nailer is an air
powered tacker. It is well
suited for fastening glazing
beads and window bars,
decorative strips and skirting
boards. The nails can be
located at easily concealed
locations of glued compo-
nents. The Finish Nailer
features a contract trip, which
requires the gun tip to be
pressed down before a shot
can be triggered.
It is suitable for driving type
SKN finishing nails of 1.0 x
1.2 mm diameter and a
length of 15 - 50 mm.
3 Safety Instructions
3.1 Regulations
For portable tackers the
standard DIN 7259 (UVV34)
is applicable. This standard
requires, that:
for tackers only the
fasteners specified in the
instructions shall be used
(see chapter „Specifica-
tions").
tackers shall only be
connected to air lines that
are controlled by a pres-
sure regulating device,
ensuring that the max.
permissible operating
pressure is not exceeded
by more than 10%.
oxygen or fuel gas is not
used as power source for
air-powered tackers.
connection to an air
supply line is only made
by means of a quick
coupler, and that the tool
is de-pressurised after
disconnection.
for maintenance and
repairs only the genuine
spare parts listed in the
parts list shall be used.
repair and maintenance
work is only carried out by
individuals authorised by
the equipment manufac-
turer or other competent
individuals, under obser-
vation of the information
given in the instructions.
As competent person is
regarded who possesses
sufficient knowledge in the
field of air-powered tackers,
obtained by vocational
training, schooling and work
experience, and who is
familiar with the applicable
legal regulations pertaining
to work safety and accident
prevention and the general
accepted technical rules to
such extent, that he/she is
capable of judging the state
of operating safety of
tackers.