anko HB956SH4PA 매뉴얼 - 페이지 9
{카테고리_이름} anko HB956SH4PA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. anko HB956SH4PA 16 페이지. Hand-held blender
페이지 인쇄
Fit the power handle inside the chopper, turn it clockwise and lock
it until you hear a slight click.
NOTE: The marks on the power handle and blender shaft should
be aligned with each other. If it is aligned, the blender shaft is
locked correctly.
Check the chopper and power cord for any damages.
Make sure your electricity supply is the same as the one shown on
the product rating label.
Connect the appliance into a mains power outlet, adjust the
desired speed setting, hold the power handle steady. Switch the
appliance ON by pressing on the switch button.
After blending, release the switch button then disconnect the
blender from mains power outlet.
WARNING: To prevent damage to the electric motor, the
continuous operating time must be less than 30 seconds.
Allow the appliance to rest at least 2 minutes between 2
running cycles. After operating 3 continuous cycles, allow
the appliance to cool down for 30 minutes before using it
again.
Never chop hot oil, fat.
If the blender gets blocked, first stop and disconnect the blender
from mains power before clearing.
After use, always disconnect from mains power outlet and remove
power handle and the lid unit in sequence, take the blade out of
the bowl by holding the plastic shaft, then pour out the food.
The edges of the blade is very sharp, do not touch them.
9