anko HB956SH4PA Manuel - Sayfa 9

Blender anko HB956SH4PA için çevrimiçi göz atın veya pdf Manuel indirin. anko HB956SH4PA 16 sayfaları. Hand-held blender

Fit the power handle inside the chopper, turn it clockwise and lock

it until you hear a slight click.

NOTE: The marks on the power handle and blender shaft should

be aligned with each other. If it is aligned, the blender shaft is

locked correctly.

Check the chopper and power cord for any damages.

Make sure your electricity supply is the same as the one shown on

the product rating label.

Connect the appliance into a mains power outlet, adjust the

desired speed setting, hold the power handle steady. Switch the

appliance ON by pressing on the switch button.

After blending, release the switch button then disconnect the

blender from mains power outlet.

WARNING: To prevent damage to the electric motor, the

continuous operating time must be less than 30 seconds.

Allow the appliance to rest at least 2 minutes between 2

running cycles. After operating 3 continuous cycles, allow

the appliance to cool down for 30 minutes before using it

again.

Never chop hot oil, fat.

If the blender gets blocked, first stop and disconnect the blender

from mains power before clearing.

After use, always disconnect from mains power outlet and remove

power handle and the lid unit in sequence, take the blade out of

the bowl by holding the plastic shaft, then pour out the food.

The edges of the blade is very sharp, do not touch them.