Druck InstruMetrics ADTS542F 안전 및 설치 매뉴얼 - 페이지 4

{카테고리_이름} Druck InstruMetrics ADTS542F에 대한 안전 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Druck InstruMetrics ADTS542F 16 페이지. Air data test set

페이지 인쇄

1.2 Intended Use

Test and calibration of aircraft aeronautical pressure instruments located indoor in a hanger or

calibration laboratory or outdoor (non-continuously) on a runway, refer to User Manual K0553 for

further information.

WARNING

atmospheres. Using this equipment in a potentially explosive atmosphere could

lead to serious injury or death.

If the equipment is used in a manner not specified by this document and K0553 the protection

provided by the equipment may be impaired.

1.3 Safety

Examine all equipment to be used, paying particular attention to electrical leads and connectors

and pneumatic pipes and connectors. DO NOT use any equipment that is known to be or

suspected to be damaged or faulty.

1.4 Power Supply

Single phase

1.5 Power Supply Connection

Do not apply electrical power outside the values stated.

Make sure that the power supply is off before connecting the power cable.

The ADTS must be connected to the correct electrical power supply as stated, adjacent to the

power connector.

RISK OF ELECTRIC SHOCK

if there is not a protective earth in place. The ADTS must, at all times, be

connected to the supply protective earth/ground.

The power supply cable and connector must be correctly rated for the power

supply. Only use power cables supplied by Druck specifically for the ADTS.

European Color

Green/Yellow

1.6 Fuses

The two High Breaking Capacity fuses (8) (see Figure 6), located in the holders and mounted on

the front panel, protect the unit. The fuses are connected in the live and neutral supply circuit and

are rated at: T5AH 250V.

1.7 Replacing a Fuse

Disconnect the electrical power supply.

Unscrew the fuse holder cap from the front panel and remove the fuse.

Fit a new fuse of the correct size and rating into the fuse holder cap.

Secure the fuse holder cap in the front panel.

2 | ADTS Safety and Installation Guide–English

This equipment is not rated for use in potentially explosive

110/230 Vac, 50/60Hz

115 Vac, 400Hz

US Color

Brown

Blue

200 VA Max - ADTS542F/ADTS552F

300 VA Max - ADTS553F/ADTS554F

There is a risk of electric shock/electrocution

Black

White

Green

Protective Earth (Ground)

Function

Live

Neutral