Drummond 58009 사용 설명서 및 안전 지침 - 페이지 4

{카테고리_이름} Drummond 58009에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Drummond 58009 9 페이지. 3/4 hp submersible sewage pump

페이지 인쇄

Installation Instructions

1. Construct a basin that is at least 30" deep

and at least 18" in diameter.

Note: Area should be cleared of small stones or gravel.

2. Secure the pump on a level, solid

base. Do not suspend the pump by the

discharge pipe, hose, or power cord.

3. Position Pump on solid surface so that both hoses

are free from kinks the Float Switch is away from the

inlet pipe and at least 1" away from all obstructions

throughout its movement. See Figure A.

4. Fit a sewage cover with a vent pipe, a hole for

the output pipe and a hole for the power cords.

Thread the Power Cords through their holes,

but do not plug them in yet. Set the

sewage cover aside for now. Place unused

end of discharge hose the other end.

Float Switch Cord

Pump Cord

Vent

Inlet

Pipe

18" Dia.

Figure A: Pump Setup

Page 4

Check Valve

(sold separately)

Sewage Cover

Discharge Pipe

1/8" Bleed Hole

For technical questions, please call 1-888-866-5797.

Note: The sewage cover must also

be fitted with a vent pipe.

5. Attach a discharge pipe to the Pump Outlet.

Note: Wrap all threaded connections

with PTFE thread seal tape.

6. Check Valve is sold separately. Install

according to manufacturer instructions.

7. To prevent excessive cycling from backflow of water,

install a check valve onto the discharge pipe. This

prevents water from flowing back after the pump

shuts off. Mount the check valve according to check

valve label to avoid the valve flapper getting stuck.

8. Drill a 1/8" diameter air bleed hole through the

Discharge Pipe just above the lower Base to

prevent Pump "airlock". A small spray of water out

of this hole is normal while the Pump is running.

9. Connect additional Discharge Pipe as needed to

direct the discharge to the main waste line for the

sewer or septic tank. The discharge should be kept

as short as possible with a minimum number of turns.

IMPORTANT: Do not exceed the

Maximum Head Lift @ 0 Flow of the Pump.

Item 58009