DRY AGER DX 1000 사용자 설명서 - 페이지 11
{카테고리_이름} DRY AGER DX 1000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DRY AGER DX 1000 14 페이지.
DRY AGER DX 1000에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)
페이지 인쇄
Changing the door hinge
The door hinge should only be changed by trained specialists. Two
people are required for the modification.
1. Open the door approx. 130°.
2. Unscrew the screw from the
hinge bracket and screw it 3-4
turns into the bearing pin.
Attention
The door must now be held by a
second person.
3. Pull out the bearing bolts.
4. Slightly tilt the door to the side
and remove it upwards.
20
5. Disengage the cover with a
small screwdriver and remove.
6. Unscrew the lock and assemble
it again on the opposite side.
7. Snap the cover into place.
8. Disengage pressure plates at
the front
and pull them
off to the rear
.
9. Unscrew the handle and screw
it back on the opposite side.
16. Slide the cover (with the
smaller opening) inwards
from the outside and snap it
into place.
10. Push on the pressure plates
until they engage.
11. Disengage the covers on the
inside, slide them outwards
and remove them.
12. Unscrew the hinge bracket.
13. Unscrew the closing bracket.
14. Screw the closing angle on
the opposite side again.
15. Screw the hinge bracket back
on the opposite side. Screw
3 screws into the marked
openings.
17. Guide the cover with the
larger opening over the hinge
bracket, slide it inwards from
the outside and snap it into
place.
18. Loosen the adjustable foot
with the enclosed wrench.
19. Pull the bolt upwards and
unscrew it from the adjust-
able foot.
20. Pull out the adjustable foot
downwards.
21. Unscrew the hinge bracket.
22. Replace the cover on the opposite
side.
23. Remove the cover, turn it 180°
and replace it on the opposite
side.
21