Anolis ArcWash Recessed 136 RGB 사용자 설명서 - 페이지 7

{카테고리_이름} Anolis ArcWash Recessed 136 RGB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcWash Recessed 136 RGB 19 페이지. Rgb

4.2 Connection to the mains

Connect the fixture to the mains with the power cord.

If the plug on the flexible cord is not the right type for your socket outlets,do not use an adaptor,but remove the plug from

the cord and discard.Carefully prepare the end of the the supply cord and fit a suitable plug.

The earth has to be connected!

The occupation of the connection-cables is as follows:

The fixture is equipped with 3-pin XLR sockets for DMX input and output. Only use a shielded twisted-pair cable designed

for RS-485 and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one fixture with

another.

Occupation of the XLR-connection:

DMX - output

XLR mounting-sockets (rear view):

Building a serial DMX-chain:

If you are using the standard DMX-controllers, you can connect the DMX-output of the controller directly with the DMX-

-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other XLR-outputs, you need to

use adapter-cables.

Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always connect output

with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ohm resistor between

Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Building a master/slave-chain:

Connect the DMX-output of the master fixture in the data-chain with the DMX-input of the first slave. Always connect output

with the input of the next slave until all slaves are connected (up to 32 fixtures).

Caution: It's necessary to insert the XLR termination plug (with 120 Ohm) into the input of the master fixture and into the

output of the last slave fixture in the link in order to ensure the proper transmission on the data link.

Cable (EU) Cable (US)

Brown

Black

Liht blue

White

Yellow/

Green

1 - Shield

2 - Signal (-)

3 - Signal (+)

International

Live

Neutral

Earth

DMX-input

XLR mounting-plugs (rear view):

DMX operation

Master/slave operation