Anolis ArcPower 72/K2 사용자 설명서 - 페이지 9

{카테고리_이름} Anolis ArcPower 72/K2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcPower 72/K2 20 페이지.

5.3. Operating via DyNet protocol

1.Unplug from the mains before installation.

.Connect LED modules to the fixtures.

Connect first fixture to the control panel which suports DyNet protocol.

3.Connect the DMX output of the first fixture in a data link with the DMX input of the second fixture. Always

connect output with the input of the next fixture until all fixtures are connected.Up to 3 fixtures can be con-

nected in data chain.

4.Insert the termination plug (with 120 Ohm) into DMX output of the last fixture in order to ensure proper trans-

mission on the data link.

5.Connect fixtures to the mains

6.Select the DyNet protocol on all fixtures (menu SPE"---> Prt---> "dYn").

A description of each byte in the DyNet protocol is the following:

Byte 0: 1C - hexadecimal Logical Message

Byte 1: 01 - Area

Byte 2: 00 – Channel level

Byte 3: 80 - Channel

Byte 4: ff – Channel Offset

Byte 5: 00 – Fade Rate

Byte 6: FF

Byte 7: 1C Checksum

Area - (0 to 255), as set on the Arcpower to give a unique address for each Arcpower unit (i.e. DMX base

address)

Channel Level - (0 to 255), level - 01=100%, FF=0%

Channel - (80 to 83), 80= channel 1, 81= channel 2, 82= channel 3, 83= channel 4, (see Channel Offset

if more than 4 channels)

Channel Offset - (0-255), default (FF)- channel offset in blocks of 4: (FF = CH 1-4, 00 = CH 5-8,

01 = CH 9-12, etc up to 3E = CH 253-256 )

Fade Rate - (0-255), fade rate with 1 second resolution (0= 0 seconds, 255= 255 seconds)

Checksum - (0-255), checksum Byte - used to ensure the integrity of the packet.

Negative two's compliment of the preceding 7 bytes.

Example 1:

0x1C,0x10,0x00,0x80,0xff,0x05,0xff,0x5

This would control channel 1 (i.e. Red) of Arcpower unit, address 16 to a Level of 100% with a fade of 5

seconds.

Example :

0x1C,0x05,0xCC,0x8,0xff,0x0A,0xff,0x5

This would control channel 3 (i.e. Blue) of Arcpower unit, address 5 to a level of 20% with a fade of 10

seconds.

(fixed value)