Dryflow Jet Force Junior 사용자 설명서 - 페이지 4

{카테고리_이름} Dryflow Jet Force Junior에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dryflow Jet Force Junior 12 페이지.

BEFORE INSTALLATION

Installation must be carried out in accordance with the current edition of the local wiring regulations

code having jurisdiction. Installation should be performed only by a qualified electrician.

If hand dryer is to be installed with hardwired

stub provided in advance of install by others.

See MT for complete reference to mounting

heights and power KO locations.

66MM[2-19/32"]

[33-55/64"]

[33-5/64"]

INSTALLATION

1. Make sure power supply breaker is switched off. Installation must adhere to the regulations of the

current edition of the local wiring code having jurisdiction. Installation should be performed only by a

qualified electrician.

2. Place Template against wall at desired height (see mounting height recommendations on MT) and mark

locations of eight (8) mounting holes and wire service entry at hard wire entrance.

Note: For two(2) or more dryers units, units should be no closer than 610MM[24"] on centres.

3. Drill the marked hole at Φ8MM / depth 38MM.

3.1 Insert Wall Anchors, Expansion [ D ] inside hole.

3.2 Fix Installation Bracket [ G ] on wall.

4. If the hand dryer is supplied in hard wire type:

860MM

Recommended

840MM

L Min. = 500 MM[19-11/16" ]

220-240V/ 12A

It is recommended to avoid installation

of dryer near high reflective objects

(mirror, stainless steel washbasins, etc.)

in order to avoid faulty function of the

presence sensor.