Drytac HOT PRESS HGP360 사용자 설명서 - 페이지 6

{카테고리_이름} Drytac HOT PRESS HGP360에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drytac HOT PRESS HGP360 19 페이지. Heated glass top vacuum press
Drytac HOT PRESS HGP360에 대해서도 마찬가지입니다: 운영자 매뉴얼 (19 페이지)

페이지 인쇄

HOT PRESS USERS MANUAL

LECTRICAL

ONNECTION

All four models of the Drytac Glass Top Vacuum Press require single-

phase AC power. The current and power requirements are different for

each model, and are summarized below.

Model

Voltage

220 - 240 VAC 50/60 Hz

Current

Current (peak)

Power

Circuit

Plug Type (NEMA)

Locking Plug Type

Please be sure to provide adequate ventilation if the equipment is to be

used in a high-volume production environment.

Make certain that the power source conforms to the requirements

speciﬁ ed above. All local electrical and safety codes, as well as the

current National Electrical Code (NEC) must be followed. All wiring

must be installed by a qualiﬁ ed electrician.

To reduce the risk of electrical shock, the vacuum press must be used

only with a properly installed 3-wire grounding-type receptacle and

plug combination. Do not use extension cords or 2-prong adapters with

this equipment. Proper grounding of the receptacle must be veriﬁ ed

before use.

The electrical cord should be routed and secured so that it does not

present a hazard. Protect the cord at all times from sharp objects, hot

surfaces, oil and chemicals. Avoid kinking the cord. Periodically inspect

the cord and plug, and replace immediately if worn or damaged.

Disconnect the equipment from the power source before moving or

servicing.

Test the GFCI (Ground Fault Circuit Interrupter) circuit breaker. It

is the circuit breaker located nearest to the center of the rear panel

of the press. It should be tested after installation (and periodically

thereafter) to ensure that it is functioning correctly. To test it, press the

test button (labeled "T") adjacent to the breaker handle. The breaker

should immediately trip. If it does not, the GFCI is defective and must

be replaced. Note that the equipment must be connected to a power

source in order to perform this test.

HGP-220

220 – 240 VAC 50/60 Hz

10 A

11 A

2.3 KW

20A

6-20P

L6-20P

HGP-260

220 - 240 VAC 50/60 Hz 220 - 240 VAC 50/60 Hz

11 A

13 A

2.5 KW

20A

6-20P

L6-20P

Electrical

HGP-360

HGP-560

18 A

22 A

4.2 KW

6.7 KW

30A

6-30P

L6-30P

25 A

28 A

30A