Drytac HOT PRESS HGP360 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Elektronarzędzie Drytac HOT PRESS HGP360. Drytac HOT PRESS HGP360 19 stron. Heated glass top vacuum press
Również dla Drytac HOT PRESS HGP360: Instrukcja obsługi (19 strony)
Drukuj stronę
HOT PRESS USERS MANUAL
E
C
LECTRICAL
ONNECTION
All four models of the Drytac Glass Top Vacuum Press require single-
phase AC power. The current and power requirements are different for
each model, and are summarized below.
Model
Voltage
220 - 240 VAC 50/60 Hz
Current
Current (peak)
Power
Circuit
Plug Type (NEMA)
Locking Plug Type
Please be sure to provide adequate ventilation if the equipment is to be
used in a high-volume production environment.
Make certain that the power source conforms to the requirements
specifi ed above. All local electrical and safety codes, as well as the
current National Electrical Code (NEC) must be followed. All wiring
must be installed by a qualifi ed electrician.
To reduce the risk of electrical shock, the vacuum press must be used
only with a properly installed 3-wire grounding-type receptacle and
plug combination. Do not use extension cords or 2-prong adapters with
this equipment. Proper grounding of the receptacle must be verifi ed
before use.
The electrical cord should be routed and secured so that it does not
present a hazard. Protect the cord at all times from sharp objects, hot
surfaces, oil and chemicals. Avoid kinking the cord. Periodically inspect
the cord and plug, and replace immediately if worn or damaged.
Disconnect the equipment from the power source before moving or
servicing.
Test the GFCI (Ground Fault Circuit Interrupter) circuit breaker. It
is the circuit breaker located nearest to the center of the rear panel
of the press. It should be tested after installation (and periodically
thereafter) to ensure that it is functioning correctly. To test it, press the
test button (labeled "T") adjacent to the breaker handle. The breaker
should immediately trip. If it does not, the GFCI is defective and must
be replaced. Note that the equipment must be connected to a power
source in order to perform this test.
HGP-220
220 – 240 VAC 50/60 Hz
10 A
11 A
2.3 KW
20A
6-20P
L6-20P
HGP-260
220 - 240 VAC 50/60 Hz 220 - 240 VAC 50/60 Hz
11 A
13 A
2.5 KW
20A
6-20P
L6-20P
6
Electrical
HGP-360
HGP-560
18 A
22 A
4.2 KW
6.7 KW
30A
6-30P
6-30P
L6-30P
L6-30P
25 A
28 A
30A