FOVNO ES-H1B 사용 설명서 - 페이지 9

{카테고리_이름} FOVNO ES-H1B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FOVNO ES-H1B 16 페이지. Electric inverted sucker bike rack

Instructions

Installation method 1

1. Place the alarm in the vehicle connect the alarm to a suitable USB power supply. If working normally a red LED light will be shown.

2. Install the handlebar suction foot and saddle suction foot on the bicycle as shown in FigureⅠ, and tie the straps tightly, with the bottom surface of all suction foots facing upwards

horizontally. Connect the hose on one of the handlebar suction foot to the other handlebar suction foot.

3. Invert the bicycle to the roof of vehicle, adjust the bicycle to be parallel to the vehicle body, adjust the position of the handlebar suction foot and the saddle suction foot , so that the

bottom surface of the suction foot fully ﬁts the installation surface.

4. As shown in FigureⅡ, select a suitable position to absorb the control box (the direction of the hose interface of the control box suction foot is towards the rear of the vehicle), and

connect the hoses of the handlebar suction foot and the saddle suction foot to the control box, so that the suction foots are completely adsorbed on the installation surface superior.

5. Before driving,check the handlebar suction foots and saddle suction foot are tight with bike and vehicle.

FigureⅠ

FigureⅡ