DSAN Limitimer PRO-2000 사용자 설명서 - 페이지 3

{카테고리_이름} DSAN Limitimer PRO-2000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSAN Limitimer PRO-2000 14 페이지. Speaker timer system
DSAN Limitimer PRO-2000에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지)

페이지 인쇄

1. Serial Connection

Options: Beep – Blink

Note: Beep and blink settings, like time settings, are set for each individual Program.

Blink on: Red light starts to blink after it comes on at Time Remaining = 0:00.

Beep: Audible cue is sounded when Time Remaining is 0:00 and when red phase light is illuminated. It

continues to beep every other second. See DIP Switch Settings to select the type of sound.

Note: Hold Beep button to manually trigger a single beep.

Signal Light Connections

Note: Signal lights may be purchased separately. (See Signal Lights and Accessories Page 10.)

Hardwire Connections

Signal lights connect with Cat-5 cable. (XLR cable can be used with KES-882 cable adapter. See

Accessories.) The cable uses twisted wire pairs to carry 12 volts, differential data, and ground

reference. Do not connect Signal Light jacks to standard network ports. Dual RJ45 jacks are available on

the rear panel (G) and one on the front panel (H) for signal light connections.

Multiple signal lights can be interconnected via daisy chain or through a power booster hub (PSL-PB6 or

PSL-PB18. See Accessories).

Limitimer® Rackmount User Guide