DSAN Limitimer PRO-2000 사용자 설명서 - 페이지 5

{카테고리_이름} DSAN Limitimer PRO-2000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSAN Limitimer PRO-2000 14 페이지. Speaker timer system
DSAN Limitimer PRO-2000에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지)

페이지 인쇄

1. Serial Connection

DIP Switch Settings

Timer and signal lights have DIP switches that control behavior particular to each device. The default

settings are all switches in the UP or ON position. Note: Signal lights use a different DIP switch labelling

where one switch position is marked "

Switch 1. Client-Server

When two or more timers are connected to one or more signal lights, set one timer as Server [ON] and

the other(s) as Client [OFF]. When only one timer is used, it must be a Server (default setting – Switch 1

UP). The Client timer acts as a thin client that sends keystroke commands to control the Server and

displays the Time Remaining. All the time processing is done on the Server.

Switch 2. Counting Program 4 (Session)

[ON];

MINUTES

SECONDS

HOURS

Switch 3. Counting Programs 1, 2, 3

[ON];

MINUTES

SECONDS

HOURS

Switch 4. Count direction

Count-Down [ON] or Count-Up [OFF].

If Count-Up, Time Remaining display shows elapsed time.

Switch 5. Count Behavior

Continue after zero [ON] else, stop display at zero. Note, in OFF mode, red light stays on until user

presses "stop".

Switch 6. Sound Volume

High [ON] Low [OFF]

Switch 7+8. Sound Selection

7. ON 8. ON None:

7. OFF 8. ON Buzz

7. ON 8. OFF Ring

7. OFF 8. OFF Chime

Switch 9. Time Settings Permission

Allow time changes while clock is running [ON]

Switch 10. Enable Wireless Transceiver

Set to [OFF] when not using Bluetooth communication

". In this context, the open position means "OFF."

OPEN

[OFF]

MINUTES

[OFF]

MINUTES

An empty sound. "Beep" pressed on timer outputs a cue to activate a

sound at a signal light that is set for an audible sound

Limitimer® Rackmount User Guide