DSAN Limitimer PRO-2000 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DSAN Limitimer PRO-2000. DSAN Limitimer PRO-2000 14 pagina's. Speaker timer system
Ook voor DSAN Limitimer PRO-2000: Handmatig (5 pagina's)
Pagina afdrukken
DIP Switch Settings
Timer and signal lights have DIP switches that control behavior particular to each device. The default
settings are all switches in the UP or ON position. Note: Signal lights use a different DIP switch labelling
where one switch position is marked "
Switch 1. Client-Server
When two or more timers are connected to one or more signal lights, set one timer as Server [ON] and
the other(s) as Client [OFF]. When only one timer is used, it must be a Server (default setting – Switch 1
UP). The Client timer acts as a thin client that sends keystroke commands to control the Server and
displays the Time Remaining. All the time processing is done on the Server.
Switch 2. Counting Program 4 (Session)
:
[ON];
MINUTES
SECONDS
HOURS
Switch 3. Counting Programs 1, 2, 3
:
[ON];
MINUTES
SECONDS
HOURS
Switch 4. Count direction
Count-Down [ON] or Count-Up [OFF].
If Count-Up, Time Remaining display shows elapsed time.
Switch 5. Count Behavior
Continue after zero [ON] else, stop display at zero. Note, in OFF mode, red light stays on until user
presses "stop".
Switch 6. Sound Volume
High [ON] Low [OFF]
Switch 7+8. Sound Selection
7. ON 8. ON None:
7. OFF 8. ON Buzz
7. ON 8. OFF Ring
7. OFF 8. OFF Chime
Switch 9. Time Settings Permission
Allow time changes while clock is running [ON]
Switch 10. Enable Wireless Transceiver
Set to [OFF] when not using Bluetooth communication
©DSan Corporation
". In this context, the open position means "OFF."
OPEN
:
[OFF]
MINUTES
:
[OFF]
MINUTES
An empty sound. "Beep" pressed on timer outputs a cue to activate a
sound at a signal light that is set for an audible sound
Limitimer® Rackmount User Guide
5