DSC PC1575RK 사용 설명서 - 페이지 6

{카테고리_이름} DSC PC1575RK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC1575RK 20 페이지. Tyco digital security control instruction manual

If An Alarm Sounds

Fire Alarm

If your system has been installed with fire detectors and the alarm sounds in a pulsing mode, follow

your emergency evacuation plan immediately (see "Fire Escape Planning" on page 15).

Intrusion Alarm

If an intrusion alarm sounds, indicated by a continuous Bell or Siren, the alarm may be silenced by

entering your access code. If the alarm was unintentional, call local authorities immediately to avoid an

unnecessary response.

You can determine the source of the alarm by following the instructions in the "Disarming" section (see

page 4 and 5). Once the source of the alarm has been corrected, the panel can be restored to its

original Armed state.

(PC5506, LCD5500 and SL-75 Keypads Only)

These keypads has five function keys – marked Stay, Away, Chime, Reset and Exit – which allow easy

single-button activation of the most commonly used features. If these keys have been enabled by your

installer , you can execute their programmed function by pressing and holding the corresponding key

(keys 1-5 on the SL-75) for two seconds.

For information regarding the operation of the function keys, talk to your alarm installer.

Programming codes from an LED Keypad:

The Master Code

To program the Master Code, enter [ ][5][current Master Code][1][new Master Code]. The Master

Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.

Press [#] to return to the Ready state.

Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We

recommend that the factory default Master Code [1234] not be used.

Additional Codes

Up to 5 additional access codes (2 through 6) may be programmed.

To program a new code:

Enter [ ][5][Master Code][code number 2 to 6][new access code]. The code number is a single digit

from 2 to 6. Access codes must be four digits unless otherwise indicated by your installer. Enter digits

0 through 9 only. Press [#] to return to the Ready state.

If an access code already exists for the code number you have selected, it will be replaced by the new

code. Be sure to record your new code(s) on the "System Information" page in this book.

To erase a code:

Enter [ ][5][Master Code][code number 2 to 6][ ]. Press [#] to return to the Ready state. Do not erase

the Master code.