DSC PC1575RK 사용 설명서 - 페이지 7

{카테고리_이름} DSC PC1575RK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC1575RK 20 페이지. Tyco digital security control instruction manual

DSC PC1575RK 사용 설명서
Programming codes from an LCD Keypad:
Master Code
Press the [ ] key to enter the function list. Scroll (< >) to...
Press [5] or [ ]. The display will read...
Press (*) for <>
Access Codes
Enter your current Master Code. The display will read...
Enter Master
Access Code
"1P" represents the Master Code. Press the [ ] key to indicate that you wish to
(*) to Edit
<>
program the Master Code. The display will read...
User Code
1P
Enter the new Master Code. The Master Code must be four digits unless otherwise
Enter New Code
indicated by your installer. Enter digits 0 through 9 only. Once the new code is
1234
<>
entered, the keypad will beep 3 times and the display will read...
Press [#] to exit the code programming function.
(*) to Edit
<>
User Code
1P
Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We
recommend that the factory default Master Code [1234] not be used.
Additional Access Codes
To erase, add or change a user code, press [ ] to enter the functions list. Use the arrow (< >) keys to
scroll to the following message...
Press [ ]. Display will read...
Press (*) for <>
Access Codes
Enter the Master Code. Display will read...
Enter Master
Access Code
Use the scroll keys (< >) to find the access code – indicated by "2P" to "6P" – you
[*] to Edit
<>
User Code
1P
wish to add, change or delete. Press the [ ] key to select the code you wish to alter.
The display will read...
Enter New Code
1234
<>
To add or change a code, enter the new code. Access codes must be four digits
unless otherwise indicated by your installer. Enter digits 0 through 9 only. To delete
an access code, enter [ ]. Once the 4 digit code or [ ] has been entered, the
keypad sounder will beep 3 times and the display will read...
[*] to Edit
<>
The "P" means the code has been programmed. If there is no "P" then that code is
User Code
1P
deleted. Press [#] to exit the code programming function. Do not erase the Master code.
Remember to record your new code(s) on the "System Information" page in this booklet.
7