DAITEM 171-21X 설치 매뉴얼 - 페이지 10
{카테고리_이름} DAITEM 171-21X에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAITEM 171-21X 18 페이지. Infared motion detector
DAITEM 171-21X에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)
페이지 인쇄GB
Fixing the detector on a swivel bracket
1. Hold the back plate against the wall in the desired
position and mark where to drill the holes.
2. Drill the holes in the wall.
3. Insert the long screw via the back plate and fasten
the plate to the wall.
4. Put the back plate cover in place.
5. Assemble both parts of the swivel.
6. Insert the mounted swivel into the long screw.
7. Position the base of the motion detector (a picture of
a man shows the top of the detector).
8. Tighten the screws lightly in order to be able to adjust
the direction of the motion detector.
9. Place the motion detector on its base and turn it so
that it is facing the right way.
Pin n° 0
for swivel
bracket
fixing
(factory-
mounted pin)
Fixing the detector flat against the wall
1. Drill through the two pre-drilling holes in the base of
the motion detector.
2. Place the base against the wall in the desired place in
order to mark where to drill the holes (a picture of a
man indicates the top of the base).
3. Drill the holes in the wall and fix the base.
4. Remove the factory-positioned pin.
5. Detach pin n° 1 from the selection supplied.
6. Position the pin in the right place.
7. Place the motion detector on its base.
Pin n° 1 for
fixing the
Pictogram
detector flat
against
the
wall
80
Pictogram
Pre-drilled holes
2 fixing
screws