DAITEM 172-21X 설치 매뉴얼 - 페이지 11
{카테고리_이름} DAITEM 172-21X에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAITEM 172-21X 18 페이지. Infared motion detector
DAITEM 172-21X에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)
페이지 인쇄Fixing the detector in a corner
1. Drill through the two pre-drilling holes in the base of
the detector.
2. Place the base against the wall in the desired place in
order to mark where to drill the holes (a picture of a
man indicates the top of the base).
3. Drill the holes in the wall and fix the base.
4. Remove the factory-positioned pin.
5. Detach pin n° 2 from the selection supplied.
6. Position the pin in the right place.
7. Place the motion detector on its base.
Pin n° 2 for
fixing the
Pictogram
detector
in a
corner
Pre-drilled holes
2 fixing screws
90°
81
5.3 Directing and testing the detector
The infrared detector has a test mode for checking:
• the power supply: the LED indicator lamp lights up
when you press the test key to confirm the battery is
operating correctly,
• the detection area: the LED indicator lamp lights up
on detection,
• the radio link (see § on checking the radio link in the
control panel manual).
)
IMPORTANT: the control panel must be in installation
mode to check the above.
"beep, test detector X,
(immediate or delayed
or combined)"
)
)
)
)
GB