DAITEM 172-21X Installatiehandleiding - Pagina 11
Blader online of download pdf Installatiehandleiding voor {categorie_naam} DAITEM 172-21X. DAITEM 172-21X 18 pagina's. Infared motion detector
Ook voor DAITEM 172-21X: Installatiehandleiding (8 pagina's)
Pagina afdrukkenFixing the detector in a corner
1. Drill through the two pre-drilling holes in the base of
the detector.
2. Place the base against the wall in the desired place in
order to mark where to drill the holes (a picture of a
man indicates the top of the base).
3. Drill the holes in the wall and fix the base.
4. Remove the factory-positioned pin.
5. Detach pin n° 2 from the selection supplied.
6. Position the pin in the right place.
7. Place the motion detector on its base.
Pin n° 2 for
fixing the
Pictogram
detector
in a
corner
Pre-drilled holes
2 fixing screws
90°
81
5.3 Directing and testing the detector
The infrared detector has a test mode for checking:
• the power supply: the LED indicator lamp lights up
when you press the test key to confirm the battery is
operating correctly,
• the detection area: the LED indicator lamp lights up
on detection,
• the radio link (see § on checking the radio link in the
control panel manual).
)
IMPORTANT: the control panel must be in installation
mode to check the above.
"beep, test detector X,
(immediate or delayed
or combined)"
)
)
)
)
GB