DSC LC-101CAM Series 설치 지침

{카테고리_이름} DSC LC-101CAM Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC LC-101CAM Series 2 페이지. Quad element pir mono/colour camera motion detector with pet immunity

페이지 인쇄

LC-101CAM

Quad Element PIR Mono/Colour Camera

Motion Detector with Pet Immunity

A n ew g en erat ion o f p rofessio nal mo vem en t sp read analyzing PIR detectors w ith Mo no / Co lo ur Camera

Video sensing device * High sensitivity and high resolution board camera. * Electronic shutter control.

Audio sensing device * Omnidirectional response.* High sensitivity.

TYPICAL INSTALLATION

Select mounting location

Choose a location most likely to intercept an intruder. (Our recommendation is a corner installation). See detection pattern (Fig.3). The quad-

element high quality sensor detects motion crossing the beam; it is slightly less sensitive detecting motion toward the detector. The LC-101CAM

performs best when provided with a constant and stable environment.

Avoid the Following Locations * Facing direct sunlight. * Facing areas that may change temperature rapidly. * Areas where there are air ducts

o r s ubs ta ntia l ai r flo ws. T h e LC- 10 1CA M per fo rm s b etter wh en pr ov i ded w ith a co ns tant a nd s tabl e en vi r onm ent.

MOUNTING DETECTOR BASE

1. To remove the front cover, unscrew the holding screw and gently raise the front cover. Fig.2-12 2. To remove the PC board, carefully unscrew

the holding screw located on the PC board. Fig.2-7 3. Put wire through the bracket and holes "A". Fig.1 4. Mount the detector base to the wall

or on the ceiling with a suitable bracket. (Install bracket). 5. Reinstall the PC board by fully tightening the holding screw. Connect wire to terminal

block. Fig.5 6. Connect the camera cable to connector in PC 7. Replace the cover by inserting it back in the appropriate closing pins and screw

in the holding screw.

DETECTOR INSTALLATION

Terminal Block Connections (See Fig.5)

Terminals 1 & 2 - Marked "T1,T2" (TAMPER) If a Tamper function is required connect these terminals to a 24-hour normally closed protective

zone in the control unit. If the front cover of the detector is opened, an immediate alarm signal will be sent to the control unit.

Terminals 3 & 4 - Marked "AUDIO: OUT, GND" This is the audio signal output. These two terminals should be connected to an audio input.

Terminals 4 & 5 - Marked "VIDEO: GND, OUT" This is the video signal output. These two terminals should be connected to video input.

Term inals 6,7 & 8 - Marked "RELAY: NO, COM & NC" These are the output relay contacts of the detector. Connect to a normally closed or

normally opened zone in the control panel.

Terminal 9 - Marked "-" (GND) Connect to the negative Voltage output or ground of the control panel.

Term inal 10 - Marked "+ "( +12V) Connect to a positive Voltage output of 8.2 -16Vdc source (usually from the alarm control unit)

FIG 1 - Knockout h oles

Series Mono/Colour

Installation Instructions

FIG 2 - Detector Installa tion

15m

FIG 3 - Lens pattern

AUDIO

VIDE O

RELAY

OUT

GND

OUT

N.O

FIG 4 - Terminal block

- 12V +