Foxfury Lighting Solutions 480-331 제품 설명서 - 페이지 9
{카테고리_이름} Foxfury Lighting Solutions 480-331에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Foxfury Lighting Solutions 480-331 12 페이지. Shield light
Foxfury Lighting Solutions 480-331에 대해서도 마찬가지입니다: 제품 설명서 (12 페이지)
페이지 인쇄SHIELD INSTALLATION
CABLE
between the battery
half for this visual)
1
1.
Clean the surface of the shield where the Battery Pack and Light Head
will be placed.
2
2.
Remove the protective plastic from the back of the provided 3M
Reclosable Fastener (P/N 51-030). Place it on the front of the Battery
Pack (see p. 3). Then, place the Battery Pack onto the back of the
shield (at desired location) and firmly press down. Ensure the strips are
perpendicular to each other to prevent detachment.
3
3.
Remove the protective plastic from the other piece of the Reclosable
Fastener and place it on the back of the Light Head. Then, place the Light
Head onto the front of the shield (at desired location) and firmly press
down.
It is recommended that the Light Head is placed on the "upper-center"
portion of the front of the shield, but it can be placed anywhere.
The Battery Pack should be placed on the back of the shield. It can
be placed anywhere as long as it is on the back of the shield.
Using the Shield Light Cable Clips (P/N 61-041) can help to secure the
Braided Cable of the Light Head.
NOTE: The Pressure Switch also has a provided Reclosable Fastener that
allows the user to place it in desired location.
PRESSURE SWITCH
BALLISTIC
SHIELD
Place the shield in
pack and Light
Head. (The shield
pictured is cut in
BATTERY PACK
LIGHT HEAD
9