AirTies Air 4920 빠른 설치 매뉴얼 - 페이지 5
{카테고리_이름} AirTies Air 4920에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AirTies Air 4920 12 페이지. Home wi-fi mesh kit
AirTies Air 4920에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (9 페이지), 자체 설치 매뉴얼 (3 페이지), 빠른 설치 쿼드 (8 페이지), 설치 매뉴얼 (2 페이지)
페이지 인쇄
State
Identifier
A
B
C
D
E
F
G
This behaviour is temporary and lasts for
about 5 seconds, after which the LEDs go
H
to one of the following states:
1) MESH with strong signal (state D), and
2) MESH with poor signal (state E).
Device has factory settings and is not
connected to the home network in any
I
way (e.g., the device is not wired to the
gateway/modem/router).
First Access Point (wired to gateway/
J
modem/router).
Access Point is part of MESH, but unable to
K
find any of its MESH partners.
This behaviour is temporary and lasts for
about 5 seconds, after which the LEDs go
L
back to the state the device was in before
the WPS attempt.
Explanation
Recommended Action(s)
Power the device on if desired.
No other action required.
No action required. If unit was just powered
on, then please wait for at least 2 minutes
for the unit to complete its boot process.
No action required. Please wait.
No action required.
Bring the device closer to another device
on the MESH network.
No action required.
No action required.
If LED is red (state E) then bring device
closer to another device on the MESH
network.
If LED is green (state D) then no action
required.
Configure device (refer to Quick Installation
Guide).
No action required.
Make sure the other device(s) that is/are
part of the MESH network is/are powered
on and close enough to connect.
On failure, repeat WPS attempt after bringing
the device closer to another device that is
already on the MESH network (i.e. in state D).
5