AirTies Air 4920 Руководство по быстрой установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по быстрой установке для Беспроводная точка доступа AirTies Air 4920. AirTies Air 4920 12 страниц. Home wi-fi mesh kit
Также для AirTies Air 4920: Руководство по быстрой установке (9 страниц), Руководство по самостоятельной установке (3 страниц), Быстрая установка Quide (8 страниц), Руководство по установке (2 страниц)
Печатать страницу
State
Identifier
A
B
C
D
E
F
G
This behaviour is temporary and lasts for
about 5 seconds, after which the LEDs go
H
to one of the following states:
1) MESH with strong signal (state D), and
2) MESH with poor signal (state E).
Device has factory settings and is not
connected to the home network in any
I
way (e.g., the device is not wired to the
gateway/modem/router).
First Access Point (wired to gateway/
J
modem/router).
Access Point is part of MESH, but unable to
K
find any of its MESH partners.
This behaviour is temporary and lasts for
about 5 seconds, after which the LEDs go
L
back to the state the device was in before
the WPS attempt.
Explanation
Recommended Action(s)
Power the device on if desired.
No other action required.
No action required. If unit was just powered
on, then please wait for at least 2 minutes
for the unit to complete its boot process.
No action required. Please wait.
No action required.
Bring the device closer to another device
on the MESH network.
No action required.
No action required.
If LED is red (state E) then bring device
closer to another device on the MESH
network.
If LED is green (state D) then no action
required.
Configure device (refer to Quick Installation
Guide).
No action required.
Make sure the other device(s) that is/are
part of the MESH network is/are powered
on and close enough to connect.
On failure, repeat WPS attempt after bringing
the device closer to another device that is
already on the MESH network (i.e. in state D).
5