Daitsu CDV-L1 설치 및 사용자 설명서 - 페이지 18
{카테고리_이름} Daitsu CDV-L1에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daitsu CDV-L1 20 페이지.
페이지 인쇄
Adjust set temperature to 30℃;
1).
Within 5 seconds, press ▼ button and then press ▲ button repeatedly for
2).
three times;
After finishing setting, "UC" is displayed on receiver light board for 5 seconds
and "MASTER" icon is displayed on wired controller.
Switching temperature scale
(5).
In unit off status, press MODE button and ▼ button simultaneously to switch
temperature scale between ℃ and ℉.
2.4 Basic operation instructions
When the main unit is energized, press ON/OFF button on the remote
(1).
controller to turn on the unit.
Press MODE button to select the desired operation mode.
(2).
Press ▲ or ▼ button to set the desired temperature (temperature setting is
(3).
not needed in auto mode).
Press FAN button to set fan speed in auto, low, medium and high speed.
(4).
2.5 Replacing batteries in remote controller and notes
Slightly press the place with OPEN, and then push out the back cover of
(1).
remote controller along the direction of arrow (as shown in Fig 3①).
Take out the original batteries (as shown in Fig 3②).
(2).
Place two 7# (AAA 1.5V) dry batteries, and make sure the position of ＋ polar
(3).
and － polar is correct (as shown in Fig 4③).
(4).
Reinstall the cover (as shown in Fig 4④)
Notes:
① .
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
When you won't use the remote controller for a long time, please take out the
② .
Fig.3
15
User's Manual of Remote Controller
Fig.4