DSC Classic PC1565 빠른 매뉴얼 - 페이지 16

{카테고리_이름} DSC Classic PC1565에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC Classic PC1565 18 페이지. Security control panels

Power Up

Common Start-Up Problems

Loss of Clock – Panel needs to have

time and date set. To do this press

[*][6][Master Code][1], then enter

time/date as: HH:MM/MM/DD/YY.

TLM – Panel has no phone line

connected. To cure this fault, enter

programming [*][8][Engineer Code]

and enter section 015. Turn off option

Zone Fault/Tamper – Incorrect zone

supervision selected. Enter program-

ming [*][8][Engineer Code] and enter

section 013. Select correct options

from 1 and 2.

Common Start-Up Problems

[*][5] Programming Access Codes

Press [*][5][Master Code]. The keypad

will flash the program light and turn

on the zone light for any codes

already programmed.

Enter the two-digit user number for

the code you want to program. The

corresponding zone light will flash.

Enter the four-digit code. The zone

light will then turn on steady. Do not

use [*] or [#] in user codes. Push the

[#] when you have finished.

To enable the code, press [*][5][Mas-

ter Code][9], and make sure that light

1 is turned on.

To allow the user to bypass zones,

turn on light 3. When you are finished,

push [#].

[*][6] User Functions

Press [*][6][Master Code]

[*] to view event buffer;

[1] to set the time and date;

[4] for system test;

[5] to enable DLS window.

[*][7] Output Functions

[*][7][Access Code] to activate Utility

Output.

[*][7][2] to activate smoke detector or

shock sensor reset.

[*] Commands